Routine maintenance

It has been a quiet few months with the heat of summer and multiple trips for work in the rear-view mirror (maybe two more this year).  Since it drizzling outside, I took the opportunity to do some preventative maintenance, simply adding another layer of spar varnish on the canoe skin.  It doesn't really need the extra, but it also doesn't hurt.


Maybe another trip next weekend.


Comments

Post a Comment

Popular posts from this blog

Washington Grist Mill to Ferry Point

Image
This post is catching up from an earlier paddle. The Washington Grist Mill and Distillery along Mt Vernon Memorial Highway used to have street parking and a put-in on either side of the road.  Since the bridge was rebuilt, this has all changed.  I parked at the Grist Mill itself and walked the canoe down a short ways down the path to the bridge. This worked fine.  The put-in is a nice grassy area and stepping over the edge of a short embankment that is popular with fishermen. The creek starts as dirty water, but starts directly in forested area and a low bridge.  The paddle develops along a wider marsh area and winds past the Ft Belvoir Marina ($10 for a car-top put-in).  Paddling father east enters Dogue Creek that widens quickly into the Potomac River.  It was very windy this day, so pushing out toward the open Potomac was a gamble, before turning around at roughly Ferry Point.       This was the first time taking the Snowshoe 12 into ...
Read more

Greenland paddle

Image
This project is from several years ago, but was worth putting into the same blog as the DIY canoe build.   My father is an avid canoer and tried making a Greenland paddle from a 2x4.  It worked, but left a lot to be desired in both structure and finish.  I once built a CNC router in the garage, so figured it could produce a wooden paddle. Experimentation started with a foam blank. I clamped it to the spoil board and cut out the first side with a roughing pass and then a horizontal finishing pass. Since my CNC can only cut 48in length, the paddle would be made using three flips and four identical operations.   The handle in the middle would be the trickiest for alignment.  In this foam test piece, I incorrectly trimmed "off" at the end. The tip end keeps a tab to maintain some structure on the last cut. This picture shows the flip, how the now lower half stands proud of the table and uses the same clamps. Onward to wood!  Specifically, starting wit...
Read more

Skin on frame canoe build

Image
 Welcome to a skin on frame canoe. I've had these plans since May 2018, and it was finally time.  It was relatively quick and was a quite relaxing process to build with wood.  The techniques are similar to building a wooden airplane. The canoe is a Snowshoe 12 from Geodesic Airolite Boats ( https://gaboats.com/ ).  It is built from plans and a small amount of kiln-dried premium hardwood lumber from Home Depot. The build process starts with creating a strongback, which is just a box-beam with legs..  Bulkhead formers were cut from 1/8" MDF and screwed to the strongback next.  This is essentially all the tooling required. Next is the milling of all the sticks.  I bought a new thin-kerf blade and built a new zero-clearance insert for the table saw for this milling operation.  The plans have a good cut-list.  It was surprisingly straightforward to turn a piece of oak and popular into several smaller pieces.  The sticks are then b...
Read more